IPFS Day Two

See the previous blog post for how I put this site on IPFS (InterPlanetary File System).

Latency of IPFS

Accessing xrop.me with Cloudflare had relatively high latency, with page loads lasting a few seconds. Instead of using IPNS (InterPlanetary Name System) names, I tested accessing the site directly through its CID (content identifier). The difference was quite significant. Loading times went from multiple seconds to a maximum of hundreds of milliseconds.

This is not suprising, as the IPFS documentation mentions this exact scenario:

“You can also use DNSLink, which is currently much faster than IPNS and also uses human-readable names.”

I had previously been attempting to use IPNS in conjunction with DNSLink. The resulting setup is not much different as compared to the prior one. In the Cloudflare DNS settings, I set the TXT DNSLink record to point to an IPFS content identifier, as can be seen here.

dns

Sustainability of IPFS on a Home Network

As I mentioned in the previous blog post, I tried to run an IPFS node on a Raspberry Pi 4. However, the daemon consumed two gigabytes of bandwidth over the span of fifteen hours, with an equal ratio of ingress to egress. Assuming that this rate of consumption stays constant, this would result in around 96 gigabytes of bandwidth being consumed in a month.

This isn’t quite as bad as when I tried to download close to 300 gigabytes of the full Bitcoin blockchain over the span of a few days (The ISP didn’t quite like that). Though, for now this resource consumption is not sustainable on my home broadband link. It seems that settings for resource constraints that can be built into the daemon have been discussed over the past few years, however such functionality is not present in the official IPFS daemon written in Go, as of the writing of this article.

For now, I have the site pinned to Pinata. However, I will probably look into other methods of contraining bandwidth.